Hoover C1404 Manual - Page 4
STEP 5 Attach handle, STEP 4 Attach cloth outer bag - bags
UPC - 073502014493
View all Hoover C1404 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
STEP 4 Attach cloth outer bag 7 8 9 B C B A 7 Note location of tapered rails (A) on back of outer bag base (B) and on front of lower handle (C). 10 F G H I B D E C 8 Slide rails on outer bag (B) onto rails on lower handle (C) until outer bag base snaps past the lock tab (D). STEP 5 Attach handle 11 D 9 The hole (E) in the handle is visible through the U-shaped extension on the outer bag base (B) when the outer bag base is in position past the lock tab (D). Be sure that power cord is pulled tight and pressed into each of the three notches (Fig. 6) before completing the following steps. 12 K NUT J 10 Note round opening (F) and hooks (G) on back of outer bag (H). Place opening over dirt tube (I). Unzip outer bag and place hand inside. Press down firmly to snap hooks into handle. 13 With outer bag to the front, place assembled handle onto handle base (J) of cleaner body. Rock handle side to side while pushing down firmly. Extra pushing effort may be required. 14 12 Press the handle release lever to move handle to the operat- ing or middle position. Push bolt (K) into hole on lower front of handle. If bolt will not go through hole easily, handle is not pushed completely down. 15 L M N O NUT 13 Place nut in recessed area (L) at back of handle. Hold nut in place while tightening bolt securely with a screw driver. Note: Only one nut is needed on this model. The extra nut is not required but has been provided for your convenience. 14 On upper front handle, grasp bag clip (M) and pull down firmly. Hook bag clip into slot in bag cap. 15 Pull switch lock (N) above ON/OFF switch (O) straight out. Dispose of lock. Note: If tab has come off during assembly, make sure switch is in the OFF position (down) before plugging cord into an electrical outlet. 4