Hoover C1415 Manual - Page 5

2-2 2-3 2-4 A B Transporting cleaner To move your cleaner from room to room, put handle in upright position, tilt cleaner back on rear wheels and push forward (A). The cleaner can also be moved by lifting it as shown in (B). Edge cleaning Edge cleaning is provided on both sides of nozzle to remove dirt in carpet near baseboards and furniture. Guide either side of nozzle parallel to edge of carpet or furniture. Belt storage Lift door to conveniently store extra belt. 3. Maintenance Emptying dirt cup Frequently check the dirt level in the dirt cup. It is recommended that you empty cup when dirt level reaches "Full Line" on front of cup. If more dirt is allowed to accumulate, your cleaner may not operate effectively and spillage may occur when cup is removed. How to empty Turn cleaner OFF and disconnect from electrical outlet. 3-1 With handle in upright position, grasp sides of cloth bag. Push sides of bag in and pull out vigorously to release dirt accumulated in bag. Allow a few seconds for dirt to settle into cup. 3-2 While supporting bottom of cup, release the two latches by pulling them outward. Remove cup and empty it. Reposition cup into support at bottom of bag and snap latches into position. The belt What to buy Use only genuine HOOVER belt, part No. 38528027 with your cleaner. When to replace Disconnect cleaner from electrical outlet. To check belt, remove bottom plate and hood as shown in "How to replace belt". Replace belt if it is stretched, cut or broken. 3-3 A C 3-4 D B How to replace Disconnect cleaner from electrical outlet. Place handle in lowest position. Turn cleaner over and remove the bottom plate screw (A). To remove bottom plate, insert end of flat screwdriver into wide area of right-hand slot (B) and push handle of screwdriver to the rear. Repeat in left-hand slot (C). Lift extension (D) of bottom plate, rotate plate and remove from cleaner body. Remove agitator and broken agitator belt.