Hoover F5807 Manual - Page 10
How to attach bare floor attachment, To clean floor - steamvac instructions
View all Hoover F5807 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Cleaning bare floors Some models come with the bare floor attachment. For others, the tool is available at additional cost from your Authorized Hoover Dealer (Depot) or a Hoover Factory Service Center. How to attach bare floor attachment Disconnect deep cleaner from electrical outlet. TANK HANDLE Push attachment against nozzle while rotating attachment downward until both ends "snap" into place. (Note: Some force may be required to rotate and snap attachment into place.) Return deep cleaner to upright position. To prevent possible leaking, remove clean solution tank by pressing down on tank handle and pulling forward; set tank aside (do not set tank on furniture.) LATCH HANDLE RELEASE PEDAL LATCH Step on handle release pedal and lower handle until it rests on the floor. Rotate recovery tank latches (one on each side of tank) outward; lift tank off machine. FOAM STRIP NOZZLE With handle in upright position, tilt deep cleaner back so that handle rests on floor. Place attachment on front of nozzle with foam strip (under netting) in position as shown. Lower handle and replace recovery tank. Press down to ensure that it is properly seated in place. Rotate latches (one on each side of tank) inward to lock tank in place. Raise handle to upright position. To clean floor Read "Before you begin cleaning" instructions on page 8. Do not use the 'SteamVac' deep cleaner on hardwood floors. Fill clean solution tank according to instructions on pages 6 and 7. Use 5 ounces of HOOVER Bare Floor Cleaner. Do not use any type of wax with your 'Steamvac' deep cleaner. Dry hands and plug deep cleaner into a properly grounded outlet. Step on handle release pedal and lower handle to operating position; turn deep cleaner ON. To release solution, press trigger. Slowly move deep cleaner forward and backward over area to be cleaned. To pick up dirty solution, release trigger and slowly move deep cleaner over area where solution has just been dispersed. Use both forward and reverse strokes. When finished cleaning, follow "After cleaning" instructions on page 9. Remove attachment from nozzle and rinse in clear water. Do not remove plastic screen or foam from attachment. 10 Cleaning bare floors