Hoover F5807 Manual - Page 6
General operation
View all Hoover F5807 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
General operation Operate deep cleaner only at voltage specified on data plate on back of cleaner. ON/OFF pedal To transport Turn deep cleaner off before transporting ON/OFF PEDAL Plug deep cleaner into a properly grounded outlet. Step on pedal to turn deep cleaner on. Step on pedal again to turn deep cleaner off. Handle release pedal To move your deep cleaner from room to room, put handle in upright and locked position, tilt deep cleaner back on wheels, and push forward. HANDLE RELEASE PEDAL Step on pedal to lower handle to operating position. Handle does not lock into a single position but "floats" to allow convenient operation. Automatic "shut-off" FLOAT DISK The deep cleaner may also be lifted by placing a hand under the upper clean solution tank handle as shown. The tanks Clean solution tank (upper tank) The clean solution tank holds the cleaning solution that is to be dispersed onto the surface to be cleaned. How to fill Disconnect deep cleaner from electrical outlet. TANK HANDLE When the recovery tank (lower tank) is full, the automatic "shutoff"mechanism will shut off the deep cleaner suction. At that time, the red float disk will rise to the top of the recovery tank lid (see illustration). The deep cleaner will no longer pick up dirty solution and the motor sound will become noticeably higher in pitch. When this happens, turn deep cleaner off and empty recovery tank before continuing use. Check clean solution tank also; it may need to be refilled. Place handle in the upright, locked position. To remove tank, press down on handle and pull forward. 6 General operation - Filling solution tank Carry tank to a sink. Rotate tank cap counterclockwise and lift up to remove cap.