Hoover F5807 Manual - Page 4
Attach lower hose holder, Storing hose and nozzle on rack - cleaner
View all Hoover F5807 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
8 12 HANDLE NOZZLE CONNECTOR CORD HOOK CLIP 1 Press cord into cord clip on back of handle. Pull cord tight (Fig. 8). Attach lower hose holder (some models only) 9 HOSE HOLDER PROJECTIONS HOLES With front of deep cleaner resting on floor, place 2 projections on lower hose holder into 2 holes on back of cleaner (Fig 9). 10 CLIP 1 2 2 To store hose on rack, begin by placing nozzle connector end of hose (straight end) into clip 1 on rack (Fig. 12). 13 1 4 2 3 Secure hose to rack at numbered locations as shown. (Fig. 13) Push screw into hole and tighten securely with a Phillips screw driver (Fig 10). Storing hose and nozzle on rack (some models only) 11 NOZZLE CONNECTOR END OF HOSE 14 EXTENSION HOOK ALIGN ARROW & HOOK FOR CONVERTER STORAGE TRIGGER CONVERTER END OF HOSE SOLUTION HOSE Stretch hose out and identify ends. Note: You may find it helpful when storing the hose and nozzle to refer to the information on the back of the deep cleaner and on the converter end of the hose (Fig. 11). 4 Assembly Converter is stored in area as shown. While aligning arrows (Fig. 14), place extension into bottom of converter opening; then push converter firmly against deep cleaner until it snaps into place. To remove, first pull top of converter off extension then pull off bottom. Secure solution hose to converter as shown.