Hoover F5808 Manual - Page 13

3-10 3-11 E F 3-12 G 5. Before connecting tube (E) to cleaner, make sure black tabs are extended by pulling tan collar toward tube. Open door on hood labeled "Stair/ upholstery Cleaning Connection". Press round solution tube connector onto round projection inside door. Press connector collar down firmly to ensure that it is fully connected. 6. The tank replaces in a hinge-like manner. Position front of lid under tabs (F) on front of tank. Rotate lid down onto tank. Make sure lid is secure on all sides before cleaning. For full suction, it is important that the recovery tank lid is properly secured before cleaning. Reverse procedure to remove hose and solution tube. Raise carpet cleaner handle to upright position. H 1. Attach tool to connector end of hose by sliding it onto connector until the tab (G) locks it securely. Using your thumb, push forward and up on the latch (H) to remove tool as shown. Follow the instructions on pages 14 and 15 for the appropriate cleaning task. 3-13 3-14 A 3-15 B C After using tool 1. Follow steps a and b for "After cleaning" on page 10. 2. Rinse tool and hose by filling sink with a small amount of water. Turn carpet cleaner ON and pick up the water with the tool. 3. Drain hose by turning carpet cleaner ON and holding end of hose up for several seconds. Do not press trigger. 4. Disconnect carpet cleaner from electrical outlet. 5. Drain solution tube by placing round end in sink and raising nozzle above your head. Press the trigger. 6. Proceed with steps c, d and e for "After cleaning" on page 10. Occasionally, debris may become lodged inside of the hose at the converter end (A). To clean out the hose, lift bottom of converter clip (B) with a screwdriver and remove clip. Remove debris as shown. Snap clip back into position making sure solution hose (C) is not pinched and moves freely. 3-16 Replace recovery tank front panel (D). Slide panel down until it snaps firmly in place. D Continued 13