Hoover F5808 Manual - Page 5

1-8 1-9 1-10 Replace clean solution tank (upper tank) by positioning bottom first. Press on tank handle to snap top of tank into place. Press cord into cord clip on back of hose holder. Pull cord tight. D E Attach lower hose holder (some models only) With front of carpet cleaner resting on floor, place 2 projections (D) on lower hose holder into 2 holes (E) on back of cleaner. 1-11 1-12 F G Push screw into hole and tighten securely with a Phillips screwdriver. H I Storing hose and nozzle on rack (some models only) Stretch hose out and identify ends. F. Nozzle connector end of hose H. Solution tube G. Trigger I. Converter end of hose Note: You may find it helpful when storing the hose and nozzle to refer to the informa- tion on the back of the carpet cleaner and on the converter end of the hose. The nozzle is stored in the area between the cord hooks (L). 1-13 J 1-14 F 1 J 4 2 1-15 K To store hose on rack, begin by placing nozzle connector end of hose (straight end) (F) into clip 1 (J) on rack. 3 Secure hose to rack at numbered locations as shown. Converter is stored in area as shown. While aligning arrows, place extension (K) into bottom of converter opening, then push converter firmly against carpet cleaner until it snaps into place. To remove, first pull top of converter off extension then pull off bottom. Secure solution hose to converter as shown. Continued 5