Hoover F5808 Manual - Page 7

2-2 2-3 2-4 C A B ON/OFF pedal & Handle release pedal Step on pedal (A) to turn carpet cleaner on. Step on pedal again to turn carpet cleaner off. Step on pedal (B) to lower handle to operating position. Handle does not lock into a single position but "floats" to allow convenient operation. Automatic "shut-off" When the recovery tank (lower tank) is full the automatic shutoff mechanism will shut off the carpet cleaner suction (suction will be noticeably reduced). At that time the yellow float disk will rise to the top of the recovery tank lid (C). The carpet cleaner will no longer pick up dirty solution and the motor sound will become noticeably higher in pitch. When this happens turn carpet cleaner off and empty recovery tank before continuing use. Check clean solution tank also; it may need to be refilled. To transport To move your carpet cleaner from room to room put handle in upright and locked position tilt carpet cleaner back on wheels and push forward. 2-5 2-6 2-7 D The carpet cleaner may also be lifted by placing a hand under the clean solution tank handle as shown. The tanks Clean solution tank (upper tank) The clean solution tank holds the cleaning solution that is to be dispersed onto the surface to be cleaned. How to fill Disconnect carpet cleaner from electrical outlet. Place carpet cleaner handle in the upright, locked position. To remove tank, press down on handle (D) and pull forward. Carry tank to a sink. Rotate tank cap counterclockwise and lift up to remove cap. Continued 7