Hoover FH40160 Product Manual - Page 9

5.3 Pull up on tank lid to separate from the base. 5.4 Pour dirty water into sink. 5.5 Check foam filter for debris before reassembly. If filter has debris, rinse with water. 5.6 When finished emptying the tank, simply place lid back onto the tank and make sure to latch the tabs on each side back into the locked position. 5.7 Tilt tank straight into position until latch snaps in place. 5.3 5.5 5.4 5.7 6. How to clean Recommended cleaning sequence NOTE: Your HOOVER® FloorMate™ Hard Floor Cleaner may be used to clean wood floors that have been sealed with a polyurethane coating and can be cleaned with water. ! CAUTION ! To prevent damage to wood floors, follow the flooring manufacturer's cleaning recommendations. If using cleaner on sealed wood floors, inspect floor surface for worn finish, bare wood or separated joints. Do not use FloorMateTM Hard Floor Cleaner to clean sealed wood floors if any of these conditions exist. 6.1 Vacuum floor to remove loose dirt, hair and debris. 6.2 Fill Clean Water Solution Tank with Hoover® 2X Multi-Floor Plus Cleaning solution and water (refer to 3.1 thru 3.7). IMPORTANT Do not use solvent based cleaning concentrates in your cleaner. Do not use any type of wax in your cleaner. Dry hands and plug cleaner into a properly grounded outlet. 6.3 Step on handle release pedal and lower handle to operating position. 6.1 6.4 6.4 Turn cleaner ON. ! CAUTION ! Do not clean over floor electrical outlets. 9 6.3