Hoover S3330 Manual - Page 4

2. How to use Cleaner description 2-1 6 7 19 3 4 17 18 5 16 2 1 11 10 9 20 15 13 14 12 8 The assembled cleaner will look like the drawing. 1. Rug and floor nozzle 2. Wand storage clip: fits into storage slots on rear and underside of canister. 3. Lightweight hose 4. Spring latch 5. Telescoping extension wand: used with rug and floor nozzle or tools. Adjusts to desired length. 6. Hand grip 7. Suction regulator: close for maximum suction, open if rug & floor nozzle is difficult to push or lightweight rugs or draperies are being cleaned. 8. Cord rewind pedal: step on pedal to rewind cord for storage. Hold plug until cord is rewound. 9. Final filter door 10. Wand storage slot 11. ON/OFF pedal 12. Large wheels: provide easy towing when cleaner is pulled over carpet, area rugs and door sills. 13. Check bag indicator: turns from green to red when paper bag should be checked for fullness. 14. Variable speed control 15. Tool lid: lift lid to reveal tool storage. 16. Bag lid 17. Bag lid latch: lift to open bag lid. 18. Hose connector 19. Carrying handle 20. Carpet/bare floor selector This cleaner is intended for household use. Operate cleaner only at voltage specified on data plate on bottom of cleaner. Polarized plug To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. 2-2 A B ON-OFF pedal Depress ON-OFF pedal (A) to turn cleaner ON or OFF. NOTE: Pedal opposite ON-OFF pedal is the cord rewind pedal (B). 4 2-3 C Rug and floor nozzle The combination rug and floor nozzle has been designed to do an efficient cleaning job on both carpet and hard surface floors. The nozzle has a BARE FLOOR setting and a CARPET setting. To change from one setting to the other, step on the pedal (C) located on top of the nozzle. 2-4 D Check bag indicator The indicator (D) will begin to show red as bag fills with dirt. When the indicator is about 2/3 red, the bag should be changed. Listed below are three conditions that will cause the indicator to become completely red. Suggested solutions are provided. 1. The bag is full; change the bag. 2. Very fine materials (such as powder) have been picked up, clogging the bag pores; change the bag, even if it is not full. 3. There is a blockage in the nozzle, hose, tools or at the bag opening; remove the blockage.