Hoover UH70040W Product Manual - Page 10
Belt replacement, HEPA Final filter, Headlight replace
View all Hoover UH70040W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
HEPA Final filter How to clean Disconnect cleaner from electrical outlet. Do not operate cleaner without dirt cup or filters in place. 3-9 A What to buy When purchasing a new HEPA filter cartridge, ask for HOOVER part No. 93002360. Headlight replacement What to buy This cleaner uses a 13 volt, T-3 114 wedge base bulb, Hoover part No. 27313-107. 3-10 With fingers in slots, pull filter frame (A) straight out. Dirt and debris can be cleaned from the filter cartridge by brushing with the cleaner's combination tool. DO NOT RINSE OR WASH the HEPA filter cartridge. Slide back into position on cleaner. Removing lens Disconnect cleaner from electrical outlet. Press handle release pedal and place handle in low position. Using a Phillips screwdriver, remove the the screw as shown and lift off lens. 3-11 Installing bulb Pull old bulb straight out of socket. Push new bulb straight into socket until locked in place. Excessive force is not required. 3-12 Replacing lens Reposition lens and secure with the screw. Belt replacement The belts are located under the bottom plate of the cleaner and should be checked from time to time to be sure they are in good condition. The flat (wide) belt is described below; the other belt is described under "Agitator brush roll". When to replace Disconnect cleaner from electrical outlet. WARNING: Agitator brush roll can start suddenly. Unplug cleaner before turning it over. To check the flat belt, remove bottom plate as shown in "Replacing flat belt". Replace belt if it is stretched, cut or broken. What to buy To assure effective operation, use only genuine HOOVER belts with your cleaner. When purchasing a new belt, ask for Flat belt - HOOVER part No. 40201-271. 10