Hoover UH70040W Product Manual - Page 13
Belt replacement, Replace belt - v belt replacement
View all Hoover UH70040W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
3-27 3-28 B 3-29 A C E 6. With curved ends down, slide end plates (C) of brush roll into slots (E) on tool. 7. Replace belt guard (B) making sure not to pinch brush bristles in guard. Turn agitator, to make sure it rotates freely. Replace and tighten screws. 8. To replace bottom plate (A), insert the four tabs on edge of bottom plate into slots on front of tool. Pivot bottom plate down and snap closed. Powered hand tool Belt replacement Inspect the belt The powered hand tool belt is designed to last a long time and is not normally replaced. However, if the belt is cracked, gouged or broken, it should be replaced. 3-30 Replace belt When replacing belt, ask for HOOVER part No. 38528-037. 3-31 B A 1. Remove tool from hose. The belt can be seen through the top of the nozzle or by removing the bottom plate and belt guard (Figs. 3-24 and 3-25). 2. Grasp turbine (A) and pull firmly to remove. 3. Remove belt from turbine pulley (B). Replace with new belt. 3-32 D C 4. With flat sides of turbine retainers (C) pointing down, slide retainers into grooves (D) in tool housing and snap into place. 5. Replace brush roll, belt guard, and bottom plate as described in Figs. 3-26 through 3-29. Continued 13