Hotpoint GSM2260NSS Installation Instructions - Page 11
IMPORTANT, Dishwasher Installation
View all Hotpoint GSM2260NSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Dishwasher Installation STEP 16: CONNECT WATER SUPPLY Connect water supply line to 90° elbow. • Slide compression nut, then ferrule over end of water line. • Insert water line into 90° elbow. • Slide ferrule against elbow and secure with compression nut. • Connect drain line to air gap, waste tee or disposer using the previously determined method. Secure hose with a screw-type clamp. Method 1 - Air gap with waste tee or disposer IMPORTANT - Check to be sure that door spring and/or door spring cable do not rub or contact the fill hose or water supply line. Test by opening and closing the door. Compression Nut Ferrule Reroute the water supply lines if a rubbing noise or interference occurs. 90° Elbow Hot Water Supply Line Waste Tee Installation Figure Y Disposer Installation Figure V 90° Elbow Door Spring STEP 17: CONNECT DRAIN LINE The molded end of the drain hose will fit 5/8" through 1" diameter inlet ports on the air gap, waste tee or disposer. • Determine size of inlet port. • Cut drain hose connector on the marked line, if required, to fit the inlet port. Cutting Line 1" 5/8" Method 2 - "High drain loop" with waste tee or disposer With this method you will need the drain hose hanger set aside in Step 1. Fasten drain hose to underside of countertop with the provided hanger. Drain Hose Hanger 32" 18" Min. Min. 32" 18" Min. Min. Waste Tee Installation Figure Z Disposer Installation IMPORTANT - When connecting drain line to disposer, check to be sure that drain plug has been removed. DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE. Figure W IMPORTANT: Do not cut corrugated portion of hose • If a longer drain hose is required and you did not purchase drain hose GPF10L, add up to 42" length for a total of 120" (10 feet) to the factory-installed hose. Use 5/8" or 7/8" inside diameter hose and a coupler to connect the two hose ends. Secure the connection with hose clamps. 2^d_[Ta 7^bT2[P\_ Figure X 7^bT2[P\_ NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEET FOR PROPER DRAIN OPERATION. Remove Drain Plug Tip: Avoid unnecessary service call charges for a no drain complaint . Make sure excess drain hose has been pulled through the cabinet opening. This will prevent excess hose in the dishwasher cavity from becoming kinked or crushed by the dishwasher. 11