Hotpoint GSM2260NSS Installation Instructions - Page 8

Three-fourths Of The Way - model

Get Hotpoint GSM2260NSS PDF manuals and user guides View all Hotpoint GSM2260NSS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

Dishwasher Installation STEP 8: POSITION WATER LINE AND HOUSE WIRING • Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher. STEP 10: SLIDE DISHWASHER THREE-FOURTHS OF THE WAY INTO CABINET IMPORTANT - Do not push against front panel with knees. Damage will occur. 4" 5" 5" 4" • Grasp the sides of the front panel and slide dishwasher into the opening a few inches at a time. 4" 6" 6" Water House Line Wiring Figure M STEP 9: INSTALL DRAIN HOSE, THROUGH CABINET • Position dishwasher in front of cabinet opening. Insert drain hose into the hole in cabinet side. If a power cord is used, guide the end through a separate hole. Insulation Blanket Maximum Drain Hose Length 10' Water Line Drain Hose House Wiring Power Cord (If Used) Figure N Tip: Prevent unnecessary service call charges for no fill, drain or noise concerns. Position utility lines so they do not interfere with anything under or behind the dishwasher. 8 Figure O Do not push against front door panel with knee. Damage to the door panel will occur. • As you proceed, pull the drain hose through the opening under the sink. Stop pushing when the dishwasher extends about 6 inches forward of adjacent cabinets. • Make sure drain hose is not kinked under or behind the dishwasher. • Make certain the house wiring, drain line and water line do not interfere with components under dishwasher. STEP 11: INSTALL TRIM PIECES (some models) Skip this step if trim is not supplied with the dishwasher. In this step you will need the trim pieces set aside in Step 1. • Position the trim pieces so the lips face toward the dishwasher door. • Select a long trim piece and press it onto the left side tub flange. Start with the top edge and press the trim piece completely onto the tub flange as you move towards the bottom. Repeat for the right side tub flange trim piece. • Install remaining trim piece on the top tub flange. CaX\BcaX_ CaX\ BcaX_ CaX\ BcaX_ C^_EXTf Figure P

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
Power Cord
(If Used)
Insulation
Blanket
Water
Line
Maximum Drain Hose
Length 10'
House
Wiring
Drain
Hose
Figure N
STEP 9:
INSTALL DRAIN HOSE,
THROUGH CABINET
• Position dishwasher in front of cabinet opening. Insert drain
hose into the hole in cabinet side. If a power cord is used,
guide the end through a
separate hole.
STEP 8:
POSITION WATER LINE
AND HOUSE WIRING
• Position water supply line and house wiring on the floor of the
opening to avoid interference with base of dishwasher and
components under dishwasher.
Figure M
Water
Line
House
Wiring
5"
5"
4"
4"
6"
6"
4"
Tip: Prevent unnecessary service call charges for no fill,
drain or noise concerns.
Position utility lines so they do not interfere with anything
under or behind the dishwasher.
Dishwasher Installation
STEP 10:
SLIDE DISHWASHER
THREE-FOURTHS OF THE WAY
INTO CABINET
IMPORTANT
–
Do not push against front panel
with knees. Damage will occur.
• Grasp the sides of the front panel and slide dishwasher into
the opening a few inches at a time.
• As you proceed, pull the drain hose through the opening
under the sink. Stop pushing when the dishwasher extends
about 6 inches forward of adjacent cabinets.
• Make sure drain hose is not kinked under or behind the
dishwasher.
• Make certain the house wiring, drain line and water line do
not interfere with components under dishwasher.
Figure O
Figure P
STEP 11:
INSTALL TRIM PIECES
(some models)
Skip this step if trim is not supplied with the dishwasher.
In this step you will need the trim pieces set aside in Step 1.
• Position the trim pieces so the lips face toward the
dishwasher door.
• Select a long trim piece and press it onto the left side tub
flange. Start with the top edge and press the trim piece
completely onto the tub flange as you move towards the
bottom. Repeat for the right side tub flange trim piece.
• Install remaining trim piece on the top tub flange.
Do not push against
front door panel with
knee. Damage to the
door panel will occur.
8