Hotpoint HPS16BTNLWW Use and Care Manual - Page 12
Installation Instructions, INSTALLATION INSTRUCTIONS
View all Hotpoint HPS16BTNLWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
INSTALLATION INSTRUCTIONS Installation Instructions INSTALLING THE WATER LINE (Cont.) BEFORE YOU BEGIN Read these instructions completely and carefully. WARNING To reduce the risk of electric shock or injury during installation, you must first unplug the refrigerator before proceeding. 1 SHUT OFF THE MAIN WATER SUPPLY AND UNPLUG REFRIGERATOR Turn on the nearest faucet (counterclockwise) long enough to clear the line of water. 2 CHOOSE THE VALVE LOCATION Choose a location for the valve that LVHDVLO\DFFHVVLEOH,WLVEHVWWR connect into the side of a vertical water pipe. When it is necessary WRFRQQHFWLQWRDKRUL]RQWDOZDWHU pipe, make the connection to the top or side, rather than at the bottom, to avoid drawing off any sediment from the water pipe. 3 DRILL THE HOLE FOR THE VALVE 'ULOOD´KROHLQWKHZDWHUSLSHHYHQLIXVLQJD self-piercing valve), using a sharp bit. Remove any burrs resulting from drilling the hole in the pipe. Take care not to allow water to drain into the drill. Failure to GULOOD´KROHPD\UHVXOW in reduced ice production or smaller cubes. 4 FASTEN THE SHUTOFF VALVE Fasten the shutoff valve to the cold water pipe with the pipe clamp. Tighten the clamp screws until the sealing washer begins to swell. NOTE: 'RQRWRYHUWLJKWHQRU\RXPD\FUXVKWKH tubing. Washer Pipe Clamp ,QOHW(QG Clamp Screw Saddle-Type 6KXWRႇ9DOYH Vertical Cold Water Pipe 4 FASTEN THE SHUTOFF VALVE (Cont.) NOTE: Commonwealth of Massachusetts Plumbing Codes 248CMR shall be adhered to. Saddle valves are illegal and use is not permitted in Massachusetts. Consult with your licensed plumber. 5 ROUTE THE TUBING Route the tubing between the cold water line and the refrigerator. Route the tubing through a hole drilled in the wall or floor (behind the refrigerator or adjacent base cabinet) as close to the wall as possible. NOTE: Be sure there is sufficient extra tubing (about 6 feet [1.82 m] coiled into 2 turns of about ´>FP@GLDPHWHU WRDOORZWKHUHIULJHUDWRUWR move out from the wall after installation. 6 CONNECT THE TUBING TO THE VALVE Place the compression nut and ferrule (sleeve) for copper tubing onto the end of the tubing and connect it to the shutoff valve. Make sure the tubing is fully inserted into the valve. Tighten the compression nut securely. For plastic tubing from a SmartConnect™ Refrigerator Tubing kit, insert the molded end of the tubing into the shutoff valve and tighten compression nut until it is hand tight, then tighten one additional turn with a wrench. Overtightening may cause leaks. Saddle-Type 6KXWRႇ9DOYH Compression Nut SmartConnect™ Tubing Packing Nut Outlet Valve Ferrule (sleeve) NOTE: Commonwealth of Massachusetts Plumbing Codes 248CMR shall be adhered to. Saddle valves are illegal and use is not permitted in Massachusetts. Consult with your licensed plumber. 7 FLUSH OUT THE TUBING Turn the main water supply on (counterclockwise) and flush out the tubing until the water is clear. Shut the water off at the water valve after about one quart (1 liter) of water has been flushed through the tubing. 12 49-1000478 Rev. 1