Hotpoint NWXR483GGWW Installation Instructions - Page 1

Installation Instructions Gas Dryer DESIGN 03 CERTIFIED If you have any questions, call 1-800-GECARES (US) or 1-800-361-3400 (Canada) or Visit our Web site at: www. GEAppliances.com BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT - Save these instructions for local inspector's use. • IMPORTANT - Observe all governing codes and ordinances. • Note to Installer - Be sure to leave these instructions with the customer. • Note to Customer - Keep these instructions with your Use and Care Book for future reference. • This dryer must be exhausted to the outdoors. • Before the old dryer is removed from service or discarded, remove the dryer door. • Service Information and the wiring diagram are located in the control console. • Service of this dryer must be performed by a qualified installer,service agency, or the gas supplier. • Do not allow children on or in the appliance. Close supervision of children is necessary when the appliance is used near children. FOR YOUR SAFETY: WARNING • Use only rigid metal or flexible metal 4-in. diameter ductwork for exhausting to the outdoors. Never use plastic or other combustible easy-to-puncture ductwork. • This appliance must be properly grounded and installed as described in these instructions. • Do not install or store appliance in an area where it will be exposed to water and/or weather. • The National Fuel Gas Code restricts installations of gas appliances in garages. They must be 18 in. off the ground and protected by a barrier from vehicles. • Install the dryer where the temperature is above 50ºF for satisfactory operation of the dryer control system. In the state of Massachusetts Installation must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the state. TOOLS YOU WILL NEED MATERIALS YOU WILL NEED SLIP JOINT PLIERS 10" ADJUSTABLE WRENCHES (2) FLAT BLADE SCREWDRIVER 4" DIA. METAL ELBOW 4" DIA. METAL DUCT (RECOMMENDED) DUCT SOAP SOLUTION CLAMPS (2) FOR LEAK DETECTION PIPE COMPOUND 4" DIA. FLEXIBLE METAL DUCT (IF NEEDED) EXHAUST HOOD 8" PIPE WRENCH LEVEL FLEXIBLE GAS LINE CONNECTOR GLOVES SAFETY GLASSES DUCT TAPE Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Verify Your Gas Installation (see section 2). Prepare the Area and Exhaust for Installation of New Dryer (see section 1). Check and Insure the Existing External Exhaust is Clean (see section 1) and Meets Attached Installation Specifications.(see section 6) Remove the Foam Shipping Pads (see section 1). Move the Dryer to the Desired Location. Level Your Dryer (see section 8). Connect the Gas Supply (see section 3) and check for leaks (see section 4). Step 8 Connect the External Exhaust (see section 7). Step 9 Connect the Power Supply (see section 5). Step 10 Check the Operation of the Power Supply, Gas Connections, and Venting. Step 11 Place the Owners Manual and the Installation Instructions in a Location Where They Will Be Noticed By the Owner. For Alcove or Closet Installation see section 9. For Bathroom or Bedroom Installation see section 10. For Mobile or Manufactured Home see section 11.