Hotpoint RB757WHWW Use and Care Manual / Warranty - Page 9

Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support Using the oven controls. (on some models) Throughout this manual, features and appearance may vary from your model. GEAppliances.com or or Oven Control, Clock and Timer Features and Settings BAkE/TEMP RECAll Pad Touch this pad to select the bake function. BAkE light Flashes while in edit mode-you can change the oven temperature at this point. Glows when the oven is in bake mode. START/ON Pad Must be touched to start any cooking or cleaning function. Display Shows the time of day, oven temperature, whether the oven is in the bake, broil or selfcleaning mode and the times set for the timer or automatic oven operations. The display will show PRE while preheating. When the oven reaches the selected temperature, the oven control will beep and the display will show the oven temperature. If "F- and a number or letter" flash in the display and the oven control signals, this indicates a function error code. If your oven was set for a timed oven operation and a power outage occurred, the clock and all programmed functions must be reset. The time of day will flash in the display when there has been a power outage. Reset the clock. If the function error code appears during the selfcleaning cycle, check the oven door latch. The latch handle may have been moved, even if only slightly, from the latched position. Make sure the latch is moved to the right as far as it will go. Touch the CLEAR/OFF pad. Allow the oven to cool for one hour. Put the oven back into operation. If the function error code repeats, disconnect the power to the range and call for service. kITChEN TIMER ON/OFF or TIMER ON/OFF pad Touch this pad to select the timer feature. Then touch the + and - pads to adjust the timer. TIMER light Flashes while in edit mode-you can change the set time at this point. Glows when the timer has been activated. Flashes again when the time has run out until the control is reset. ClOCk Pad To set the clock, press this pad twice and then press the + and - pads. The time of day will flash in the display when the oven is first turned on. START TIME ON/OFF Pad (on some models) Use along with the COOKING TIME ON/OFF or SELF CLEAN pads to set the oven to start and stop automatically at a time you set. START TIME light Flashes while in edit mode-you can change the start time at this point. Glows when the function has been activated. COOkING TIME ON/OFF Pad (on some models) Touch this pad and then touch the + or - pads to set the amount of time you want your food to cook. The oven will shut off when the cooking time has run out. COOkING TIME light Flashes while in edit mode-you can change the set time at this point. Glows when the function has been activated. Flashes again when the time has run out until the control is reset.