Hotpoint RB757WHWW User Guide - Page 36
Installation Instructions, PREPARE TO INSTALL THE RANGE
View all Hotpoint RB757WHWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Installation Instructions PREPARE TO INSTALL THE RANGE MATERIALS YOU MAY NEED Tin Snips Lag Bolts Anchor Sleeves (For Anti-Tip Bracket Mounted on Concrete Floors Only) (UL Approved 40 AMP) 4-Wire Cord OR 3-Wire Cord 4' Long 4' Long Squeeze Connector (For Conduit Installations Only) TOOLS YOU WILL NEED Drill with 1/8" Bit Adjustable Wrench Pliers Safety Glasses Tape Measure Pencil 2 PREPARE THE OPENING Allow 11⁄2″ spacing from the range to adjacent vertical walls above the cooktop surface. Allow 30″ minimum clearance between the surface units and the bottom of unprotected wood or metal top cabinet, and 15″ minimum between the countertop and adjacent cabinet bottom. EXCEPTION: Installation of a listed microwave oven or cooking appliance over the cooktop shall conform to the installation instructions packed with that appliance. If cabinet storage is installed, reduce the risk by installing a range hood that projects horizontally a min. of 5″ beyond the bottom of the cabinets. Make sure the wall covering, countertops and cabinets around the range can withstand heat generated by the range, oven or cooktop up to 200°F. Not less than Hood the width of the range 5″ Min. 30″ 15″ Min. Min. Wall Locate the outlet box within either shaded area. 1/4" Nut Driver Phillips Screwdriver Level Flat-blade Screwdriver 11⁄2″ Min. Wall 71⁄2″ Install the outlet box on either side of the CL Outlet box Cord CL of range 7″ 71⁄2″ 31⁄2″ 5″ Floor 21⁄4″ PARTS INCLUDED Anti-Tip Bracket Kit 1 REMOVE SHIPPING MATERIALS Remove packaging materials. Failure to remove packaging materials could result in damage to the appliance. 35 Flooring under the range Your range, like many other household items, is heavy and can settle into soft floor coverings such as cushioned vinyl or carpeting. When moving the range on this type of flooring, it should be installed on a 1/4″ thick sheet of plywood (or similar material) as follows: When the floor covering ends at the front of the range, the area that the range will rest on should be built up with plywood to the same level or higher than the floor covering. This will allow the range to be moved for cleaning or servicing.