Hunter 20174 Owner's Manual - Page 11

8 • Completing Your Installation With a Bowl Light Fixture Your Hunter fan comes with an integrated light fixture assembly. WARNING: Use only the light fixture supplied with this fan model. 8-1. To attach the heat shield assembly, partially install two housing assembly screws into the switch housing mounting plate. 8-2. Feed the upper plug connector through the center opening of the shield. 8-3. Align the keyhole slots in the housing with the assembly screws. 8-4. Turn the housing counterclockwise until the housing assembly screws are firmly situated in the narrow end of the keyhole slots. Install the remaining screw into the housing. Tighten all three screws firmly. CAUTION: Make sure the heat shield assembly is securely attached to the housing mounting plate. Failure to properly attach and tighten all three assembly screws could result in the heat shield assembly and light fixture falling. Steps 8-1 - 8-4 Assembly Screw Heat Shield Assembly Note: In compliance with US federal energy regulations, this ceiling fan contains a device that restricts the light kit to a maximum of 190 Watts. Exceeding that limit or the marked limit on this product may result in fire hazard or improper operation. 11 45007-01 • 06/11/09 • Hunter Fan Company