Hunter 20174 Owner's Manual - Page 6

3 • Assembling and Hanging the Fan 3-1. To assemble fan to hang down from a flat or angled ceiling, place the canopy and canopy trim ring around the adapter so that they rest on the fan assembly. 3-2. Feed the wires from the fan through the downrod. Note: Make sure all the wires are on the same side of the metal dowel pin inside the dowrod. 3-3. Loosen the square head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers. CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod. WARNING: Do not carry or lift fan by canopy. 3-4. Raise the fan and place the ball into the hanger bracket. 3-5. Align the notch on the ball with the indent in the hanger bracket. (Rotate the fan until you hear the notch pop into place.) Go to 4 • Wiring the Fan. WARNING: Fan may fall if not assembled as directed in these installation instructions. Steps 3-1 - 3-3 Adapter Steps 3-4 - 3-5 Downrod Canopy (with Washer) Canopy Trim Ring Set Screw Indent 6 45007-01 • 06/11/09 • Hunter Fan Company