Hunter 25522 Owner's Manual - Page 6
installing the canopy, assembling the blades, installing the switch housing
View all Hunter 25522 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
6 CAUTION: Be sure no bare wire or wire strands are visible after making connections. All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, you should use a qualified electrician. Wall Switch Wire for Separate Control of Light Fixture Power Wires in Ceiling Black White (Note: Wall switch must be acceptable as a general-use switch.) Bare or Green 2 x 4 Brace Outlet Box Approved Connectors Green Ground Wire from Hanger Pipe (not present with flush mounting option) White Black 1 2 Blk/Wht 3 Wires from Fan Ceiling Plate Connections: 1. Connect Blk/Wht wire from the fan to the wall switch for separate control of the light fixture, or 2. Connect Blk/Wht wire from the fan to the ceiling black wire if there is no separate wall switch wire for the light fixture. Figure 12 - Wiring the fan installing the canopy 1. Rotate the fan 180º clockwise from the initial position when hanging the fan. The arrows on the hanger ball and on the ceiling plate should be pointing in the same direction and should be pointing towards the tab hole on the canopy. Refer to Figure 13. Tab Hole and Tab Canopy Screw Figure 14 - Installing the canopy assembling the blades 1. Remove the blade mounting screws and rubber shipping bumpers from the motor. 2. For each blade, insert one blade mounting screw through the blade iron as shown in Figure 15, and attach lightly to the fan. Insert the second blade mounting screw, then securely tighten both mounting screws. Figure 15 - Attaching the blade iron to the fan installing the switch housing attaching the upper switch housing 1. Remove and save the three screws and lock washers from the mounting plate located at the end of the motor shaft. 2. Feed the upper plug connector through the center opening of the switch housing gasket and the upper switch housing. See Figure 16. Figure 13 - Rotating the fan 2. Hook the tab hole over the tab on the ceiling plate as shown in Figure 14. 3. Raise the canopy, be sure the holes in the canopy and the ceil- ing plate are aligned, and loosely assemble the canopy screws one at a time. When all three screws are assembled, securely tighten all three canopy screws. Refer to Figure 14. 41877-01 06/14/2007 Switch Housing Mounting Plate Switch Housing Gasket Upper Switch Housing Housing Assembly Screw Upper Plug Conntector Figure 16 - Attaching the upper switch housing to the mounting plate © 2007 Hunter Fan Company