Hunter 25522 Owner's Manual - Page 7
attaching the lower switch housing, installing the light fixture, installing without the light
View all Hunter 25522 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. Assemble the upper switch housing to the mounting plate using the three screws and lockwashers which you removed from the mounting plate. Tighten the screws securely. CAUTION: Make sure the upper switch housing is securely attached to the switch housing mounting plate. Failure to properly attach and tighten all three housing assembly screws could result in the switch housing and light fixture falling. attaching the lower switch housing 1. Connect the upper plug connector from the motor to the lower plug connector in the lower switch housing assembly. See Figure 17. NOTE: Both plug connectors are polarized and will only fit together one way. Make sure that both connectors are properly aligned before connecting them together. Incorrect connection could cause improper operation and damage to the product. Lower Plug Connector Housing Assembly Screw Upper Switch Housing Upper Plug Connector Lower Switch Housing Figure 17 - Connecting the plug connectors 2. Place the lower switch housing assembly over the upper switch housing. Align the side screw holes in the upper and lower switch housings. Attach the lower switch housing to the upper switch housing with three #6-32 x 3/8" housing assembly screws. See Figure 17. installing the light fixture 1. Install the included CFL bulb. 2. Align the notches in the globe assembly with the bumps on the fitter. 3. Twist the globe assembly clockwise until it locks in place. 4. Be sure that the holes in the fitter cover and globe assembly align as shown in Figure 18. If they do not, remove the globe assembly and begin with step 2 in a different position. 7 Notch in Globe Assembly Fitter Fitter Cover Globe Assembly Figure 18 - Installing the globe assembly installing without the light fixture 1. Install the upper switch housing as shown in the attaching the upper switch housing section. 2. Disconnect the two single plug connectors in the lower switch housing. Place the dummy terminals (in the sack parts) on the end of each single plug connector. The female dummy terminal must be placed on the male plug connector and the male dummy terminal on the female plug connector. 3. Remove the fitter assembly from the lower switch housing by removing the two screws inside of the fitter as shown in Figure 19. Fitter Remove these screws Figure 19 - Removing the fitter assembly 4. Install the lower switch housing as shown in the attaching the lower switch housing section. 5. Install the cap and plug button as shown in Figure 20. Cap Plug Button Figure 20 - Installing the cap and plug button 41877-01 06/14/2007 © 2007 Hunter Fan Company