Hunter 25867 Owner's Manual - Page 10

5 • Wiring the Fan All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70-1999. If you are unfamiliar with wiring, use a qualified electrician. Wall switches are not included. Select an acceptable general-use switch in accordance with national and local electrical codes. 5-1. Before attempting installation, make sure the power is still off. 5-2. To connect the wires, hold the bare metal leads together and place a wire connector over them, then twist clockwise until tight. For all these connections use the wire connectors provided. 5-3. Connect the bare or green ground wire (grounded) from the ceiling to the green ground wire (grounded) from the ceiling plate and the green ground wire from the fan. 5-4. Connect the white wire (ungrounded) from the ceiling to the white wire (ungrounded) from the fan. 5-5. Connect the remaining wires as follows: Single Switch Wiring: • The black wire (ungrounded) from the ceiling to the black (ungrounded) and the black/white wire (ungrounded) from the fan CAUTION: Be sure no bare wire or wire strands are visible after making connections. 5-6. Turn the splices upward and push them carefully back through the ceiling plate into the outlet box. 5-7. Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box. fsdfsdf Wire Connector Single Switch Wiring 10 42774-01 • 06/12/09 • Hunter Fan Company