Hunter 25867 Owner's Manual - Page 9
For Standard or Angled mounting, For Low Profile mounting
View all Hunter 25867 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
4 • Assembling and Hanging the Fan WARNING: Fan may fall if not assembled as directed in these installation instructions. 4-1. Unbundle the wires from the fan. For Standard or Angled mounting: 4-2. To assemble fan to hang down from a flat or angled ceiling, insert the downrod through the canopy and canopy trim ring. Feed the wires from the fan through the downrod. 4-3. Loosen the square head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers. Skip to Step 4-7. CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod. For Low Profile mounting: Note: For low profile mounting, the downrod is replaced with the low profile washer. 4-4. Remove the set screw from the adapter. 4-5. Place the low profile washer (lip up) into the canopy. Be sure the green ground wire is pointing up toward the ceiling. 4-6. Align the holes in the washer with the holes in the adapter. Assemble securely with three low profile screws. 4-7. Raise the fan and place the hook on the ceiling plate through the U-shaped hole in the rim. Step 4-7 U-shaped Hole Steps 4-2 - 4-3 Downrod Canopy Canopy Trim Ring Set Screw Steps 4-5 - 4-6 Low Profile Washer Low Profile Screw 9 42774-01 • 06/12/09 • Hunter Fan Company