Hunter 28425 Operation Manual - Page 10
installing the remote cradle on a rocker light switch
View all Hunter 28425 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
10 installing the remote cradle on a standard light swtich 1. Remove the two screws holding the switch cover plate. Do not remove the cover plate. 2. Orient the control cradle as shown in Figure 28. Line up the two inner mounting holes with those on the switch, insert screws and don't over tighten. installing the remote cradle on the wall 1. Locate a 2 x 4 wall stud in a convenient location. 2. Orient the remote cradle as shown in Figure 30, over the 2 x 4 stud. 3. Use the 1" wood screws in either the inner or outer mounting holes. NOTE: Wall anchors and 6-32 x 1" screws may be used in situations where mounting to a stud is not possible. Use the inner mounting holes. Figure 28 - Installing the remote cradle on a standard light switch 3. Continue to installing the battery. installing the remote cradle on a rocker light switch 1. Break off the two tabs by pushing outward. See Figure 29. 2. Remove the two screws holding the switch cover plate. Do not remove the cover plate. 3. Orient the remote cradle as shown in Figure 29. Line up the two outer mounting holes with those on the switch, insert screws and don't over tighten. Figure 30 - Installing the remote cradle on the wall 4. Continue to installing the battery. installing the battery 1. Remove th cover off the back of the remote as shown in Figure 31. 2. Install the included 12 volt alkaline battery (Type 23A, MN-21 or equivalent) inside the remote, matching polarity on the battery as indicated by the + and - symbols in the Battery Compartment. See Figure 31. Replace the cover. Back of Remote Figure 29 - Installing the remote cradle on a rocker light switch 4. Continue to in installing the battery. 41860-01 02/24/2005 Battery Compartment Dip Switches Cover Figure 31 - Installing the battery and setting the dip switches © 2005 Hunter Fan Company