Hunter 28425 Operation Manual - Page 5
assembling the fan
View all Hunter 28425 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Isolators Ceiling Plate Figure 8 - Inserting the isolators into the ceiling plate 4. Align the slotted holes (refer to Figure 9) in the ceiling plate with the pilot holes in the wood support structure. Note: The isolation pads should be flush against the ceiling. For Angled Ceilings: Be sure to orient the ceiling plate so that the arrows on the ceiling plate are pointing towards the ceiling peak. Refer to Figure 9. Slots 5 assembling the fan installing the downrod 1. Insert the downrod through the canopy, the canopy trim ring, the adapter cover as shown in Figure 11. Downrod Canopy Canopy Trim Ring Adapter Cover Arrows for Orienting on Angled Ceiling Figure 9 - Locating the slotted holes to use 5. Place a flat washer on each of the two 3" screws and pass the screws through the slotted holes in the ceiling plate as shown in Figure 10. 6. Tighten the screws into the 9/64" pilot holes; do not use lubricants on the screws. Do not overtighten. Ceiling Joist 2 x 4 Brace Figure 11 - Installing the downrod 2. Feed the wires from the fan through the downrod. 3. Screw the downrod into the fan until tight. 4. Tighten the allen head set screw on the adapter as shown in Figure 12. Ceiling Plate Flat Washer Ceiling Outlet Box 3" Wood Screw Figure 10 - Installing the ceiling plate Allen Head Set Screw Figure 12 - Installing the downrod WARNING: Failure to securely tighten the set screw on the adapter could cause the fan to fall. CAUTION: The downrod has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod. © 2005 Hunter Fan Company 41860-01 02/24/2005