Hunter 28425 Operation Manual - Page 12
cleaning your ceiling fan, troubleshooting
View all Hunter 28425 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
12 controlling the light Turn the up and down light on or off independently from the fan by press the UP LIGHT or DOWN LIGHT button. When the light is on,press the UP LIGHT or the DOWN LIGHT button 1 time for a gradual off (light dims from full brightness to completely off) or press the UP LIGHT or DOWN LIGHT button 2 times for an instant off. Press one of the light buttons for longer than 1 second, it becomes a dimmer. The light varies from 'bright' to 'dim' over approximately 8 seconds. This sequence will reverse the light when it reaches the brightest or dimmest level if you continue to hold one of the LIGHT buttons. Release the button when the desired level is reached. With the Auto Resume feature, a quick (pressing less than 1 second) on/off operation of the LIGHT buttons maintains the desired brightness level set previously. cleaning your ceiling fan caring for finishes For cleaning, a soft brush or lint-free cloth should be used to prevent scratching the finish. A vacuum cleaner brush nozzle can remove heavier dust. Surface smudges or an accumulation of dirt and dust can easily be removed by using a mild detergent and a slightly dampened cloth. An artistic agent may be used, but never use abrasive cleaning agents as they will damage the finish. caring for blades Wood finish blades should be cleaned with a furniture polishing cloth. Occasionally, a light coat of furniture polish may be applied for added protection and beauty. Painted and high-gloss blades may be cleaned in the same manner as the fan finish. troubleshooting Problem: Nothing happens; fan does not move. 1. Turn power on, replace fuse, or reset breaker. 2. Loosen canopy, check all connections according to the wiring the fan section. 3. Check the plug connection in the switch housing. 4. Remove the shipping bumpers. 5. Install a new battery in the remote. 6. Change dip switch settings. Problem: Noisy operation. 1. Tighten the blade bracket screws until snug. 2. Tighten the blade screws until snug. 3. Check to see if the blade is cracked. If so, replace all the blades. 4. Change to an approved speed control. 5. Check and tighten the screws in the switch housing mounting plate and in the upper and lower switch housing. Problem: Excessive wobbling. 1. If your fan wobbles when operating, use the enclosed balancing kit and instructions to balance the fan. 2. Tighten all blade and/or blade iron screws. 3. Turn power off, support fan very carefully, and check that the hanger ball is properly seated. If you need parts or service assistance, please call 888-830-1326 or visit us at our WEB site at http://www.hunterfan.com. Hunter Fan Company 2500 Frisco Avenue Memphis, Tennessee 38114 41860-01 02/24/2005 © 2005 Hunter Fan Company