Husqvarna 125B Owners Manual - Page 11
Fuel Handling - won t start
View all Husqvarna 125B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
FUEL HANDLING Fuel mixture CAUTION! The machine is equipped with a two--stroke engine and must always be run using a mixture of gasoline and two-stroke engine oil. It is important to accurately measure the amount of oil to be mixed to ensure that the correct mixture is obtained. When mixing small amounts of fuel, even small inaccuracies can drastically affect the ratio of the mixture. WARNING: Always ensure there is adequate ventilation when handling fuel. S Always start by filling half the amount of the gasoline to be used. Then add the entire amount of oil. Mix (shake) the fuel mixture. Add the remaining amount of gasoline. S Mix (shake) the fuel mixture thoroughly before filling the machine's fuel tank. Gasoline CAUTION! Always use high quality unleaded gasoline. S This engine is certified to operate on unleaded gasoline. S The lowest recommended octane rating is 87. If you run the engine on lower octane rating than 87, "knocking" can occur. This leads to an increased engine temperature, which can result in a serious engine breakdown. S When working at continuous high revs a higher octane rating is recommended. Two--stroke oil S For great results and performance use HUSQVARNA two--stroke oil, which is specially formulated for our two--stroke engines. Mixture 1:50 (2%). S To maximize the life of your blower, you may choose to use a high quality synthetic oil formulated for two--stroke engines. Mixture 1:50 (2%). S Never use two--stroke oil intended for water--cooled outboard engines, sometimes referred to as outboard oil. S Never use oil intended for four--stroke engines. Gasoline U.S. gallon 1 2 1/2 5 Two- stroke oil 2% (1:50) U.S. fl. oz. 2 1/2 6 1/2 12 7/8 Mixing S Always mix the gasoline and oil in a clean container intended for fuel. S Do not mix more than one month's supply of fuel at a time. S If the machine is not used for some time, the fuel tank should be emptied and cleaned. WARNING: The catalytic con- verter muffler gets very hot during and after use. This also applies during idling. Be aware of the fire hazard, especially when working near flammable substances and/or vapors. Fueling WARNING: Taking the following precautions, will lessen the risk of fire: Do not smoke or place hot objects near fuel. Always shut off the engine before refueling. Always stop the engine and let it cool for a few minutes before refueling. When refueling, open the fuel cap slowly so that any excess pressure is released gently. Tighten the fuel cap carefully after refueling. Always move the machine away from the refueling area before starting. 545154658 Rev. 2 7/10/07 English--- 11