Husqvarna 1827EXLT Owners Manual - Page 10

MUFFLER GASOLINE FILLER CAP CHOKE CONTROL SAFETY IGNITION KEY ON / OFF SWITCH PRIMER FUEL SHUT-OFF VALVE RECOIL (AUXILIARY) STARTER HANDLE OPERATION ELECTRIC START BUTTON AUGER CONTROL LEVER POWER CORD PLUG DISCHARGE CHUTE CONTROL LEVER DRIVE SPEED CONTROL LEVER CODNERTFRELMOELOCTLTEEOVRERTCROANCDTTRRIIOOVNEL LEVER CHUTE DEFLECTOR LH TURN TRIGGER CLEAN-OUT TOOL LIGHT HANDLE KNOB NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. DISCHARGE CHUTE MUFFLER TOOLBOX DRIFT CUTTER AUGERS FIG. 10 SKID PLATE MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Drive speed control lever - used to select forward or reverse motion and speed of snow thrower. Freewheel control - disengages transmission for pushing the snowthrower with the engine off. Traction drive control lever - used to engage power-propelled forward or reverse motion of snow thrower. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Auger control lever - used to engage auger motion (throw snow). Electric start button - used for starting the engine. Discharge chute control lever - used to change the direc- Recoil (auxiliary) starter handle - used for starting engine. tion the snow is thrown. Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. Deflector remote control lever - used to change the distance the snow is thrown. Choke Control - used for starting a cold engine. ON / OFF switch - used to STOP the engine. LH and RH turn triggers - used to steer the snow thrower. Skid plate - used to adjust height of scraper bar from the ground. Drift cutter - used to cut through deep snowdrifts. 10