Husqvarna 1827EXLT Owners Manual - Page 22
Troubleshooting
View all Husqvarna 1827EXLT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
TROUBLESHOOTING See appropriate section in manual unless directed to an authorized service center/department. PROBLEM Does not start Loss of power Engine idles or runs roughly Excessive vibration Recoil starter is hard to pull Loss of traction drive / slowing of drive speed Loss of snow discharge or slowing of snow discharge CAUSE CORRECTION 1. Fuel shut-off valve (if so equipped) 1. Turn fuel shut-off valve to OPEN position. in OFF position. 2. Safety ignition key is not inserted. 2. Insert safety ignition key. 3. Out of fuel. 3. Fill fuel tank with fresh, clean gasoline. 4. Throttle in STOP position (or ON/ 4. Move throttle to FAST position (or ON/OFF switch to ON position). OFF switch is OFF). 5. Choke in OFF position. 5. Move to FULL position. 6. Primer not depressed. 6. Prime as instructed in the Operation section of this manual. 7. Engine is flooded. 7. Wait a few minutes before restarting, DO NOT prime. 8. Spark plug wire is disconnected. 8. Connect wire to spark plug. 9. Bad spark plug. 9. Replace spark plug. 10. Stale fuel. 10. Empty fuel tank & carburetor, refill with fresh, clean gasoline. 11. Water in fuel. 11. Empty fuel tank & carburetor, refill with fresh, clean gasoline. 1. Spark plug wire loose. 1. Reconnect spark plug wire. 2. Throwing too much snow. 2. Reduce speed and width of swath. 3. Fuel tank cap is covered with ice or 3. Remove ice and snow on and around fuel tank cap. snow. 4. Dirty or clogged muffler. 4. Clean or replace muffler. 1. Choke is in FULL position. 1. Move choke to OFF position. 2. Blockage in fuel line. 2. Clean fuel line. 3. Stale fuel. 3. Empty fuel tank & carburetor, refill with fresh, clean gasoline. 4. Water in fuel. 4. Empty fuel tank & carburetor, refill with fresh, clean gasoline. 5. Carburetor is in need of adjustment 5. Contact an authorized service center/department. or overhaul. 1. Loose parts or damaged augers or 1. Tighten all fasteners. Replace damaged parts. If vibration impeller. remains, contact an authorized service center/department. 1. Frozen recoil starter. 1. See "IF RECOIL STARTER HAS FROZEN" in the Operation section of this manual. 1. Drive belt is worn. 1. Check / replace drive belt. 2. Drive belt is off of pulley. 2. Check / reinstall drive belt. 3. Friction drive wheel is worn. 3. Contact an authorized service center/department. 4. Excessive snow and ice build up in 4. Remove snow and ice build up from in between track compo- between track components. nents. 1. Auger belt is off of pulley. 1. Check / reinstall auger belt. 2. Auger belt is worn. 2. Check / replace auger belt. 3. Clogged discharge chute. 3. Clean snow chute. 4. Augers / impeller jammed. 4. Remove debris or foreign object from augers / impeller. 22