Husqvarna 525P4S Operation Manual - Page 19

STARTING AND STOPPING Check before starting Starting and stopping • Inspect the working area. Remove any objects that could be thrown out. • Check the cutting attachment. Never use blunt, cracked or damaged equipment. • Check that the machine is in perfect working order. Check that all nuts and screws are tight. • Make sure the chain is adequately lubricated. • Check that the cutting attachment always stops when the engine is idling. • Only use the machine for the purpose it was intended for. • Make sure that the handle and safety features are in good working order. Never use a machine that lacks a part or has been modified outside its specifications. Filling with oil WARNING! The complete clutch cover ! and shaft must be fitted before the machine is started, otherwise the clutch can come loose and cause personal injury. Always move the machine away from the refuelling area and source before starting. Place the machine on a flat surface. Ensure the cutting attachment cannot come into contact with any object. Make sure no unauthorised persons are in the working area. Otherwise there is a risk of serious personal injury. The safety distance is 15 meters. Starting • Open the cap on top of the bar head Primer bulb: Press the air purge repeatedly until fuel begins to fill the bulb. The bulb need not be completely filled. • Fill with Husqvarna saw chain oil. • Refit the cap. Choke: Set the choke control in the choke position. WARNING! When the engine is started ! with the choke in choke position the cutting attachment will start to rotate immediately. English - 19