Husqvarna 525P4S Operation Manual - Page 9
Cutting equipment, Specification of bar and saw chain
View all Husqvarna 525P4S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
GENERAL SAFETY PRECAUTIONS WARNING! Mufflers fitted with catalytic ! converters get very hot during use and remain so for some time after stopping. This also applies at idle speed. Contact can result in burns to the skin. Remember the risk of fire! • Keep the chain properly tensioned! If the chain is slack it is more likely to jump off and lead to increased wear on the bar, chain and drive sprocket. WARNING! The inside of the muffler ! contain chemicals that may be carcinogenic. Avoid contact with these elements in the event of a damaged muffler. • Keep cutting equipment well lubricated and properly maintained! A poorly lubricated chain is more likely to break and lead to increased wear on the bar, chain and drive sprocket. WARNING! ! The exhaust fumes from the engine are hot and may contain sparks which can start a fire. Never start the machine indoors or near combustible material! Cutting equipment This section describes how you can achieve maximum clearing capacity and extend the life of the cutting attachment through correct maintenance and using the right type of cutting attachment. • Only use cutting equipment recommended by us! • Keep the chain's cutting teeth properly sharpened! Follow our instructions and use the recommended file gauge. A damaged or badly sharpened chain increases the risk of accidents. • Maintain the correct raker clearance! Follow our instructions and use the recommended raker gauge. Too large a clearance increases the risk of kickback. WARNING! Never use a machine with ! faulty safety equipment. The machine's safety equipment must be checked and maintained as described in this section. If your machine fails any of these checks contact your service agent to get it repaired. WARNING! Always stop the engine ! before doing any work on the cutting attachment. This continues to rotate even after the throttle has been released. Ensure that the cutting attachment has stopped completely and disconnect the spark plug cap before you start to work on it. Specification of bar and saw chain When the cutting attachment supplied with your machine has to be replaced, because it is worn out or damaged, you must only fit the types of bar and saw chain recommended by us. Guide bar • Length (inches/cm) English - 9