Husqvarna 572 XP Owner Manual - Page 30
To examine the cutting equipment, To do a check of the guide bar, To do maintenance on the fuel tank
View all Husqvarna 572 XP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
To examine the cutting equipment 1. Make sure that there are no cracks in rivets and links and that no rivets are loose. Replace if it is necessary. 4. Examine the groove in the guide bar for wear. Replace the guide bar if it is necessary. 5. Examine if the guide bar tip is rough or very worn. 2. Make sure that the saw chain is easy to bend. Replace the saw chain if it is rigid. 3. Compare the saw chain with a new saw chain to examine if the rivets and links are worn. 4. Replace the saw chain when the longest part of the cutting tooth is less than 4 mm/0.16 in. Also replace the saw chain if there are cracks on the cutters. 6. Make sure that the bar tip sprocket turns freely and that the lubricating hole in the bar tip sprocket is not blocked. Clean and lubricate if it is necessary. To do a check of the guide bar 1. Make sure that the oil channel is not blocked. Clean if it is necessary. 7. Turn the guide bar daily to extend its life cycle. 2. Examine if there are burrs on the edges of the guide bar. Remove the burrs using a file. 3. Clean the groove in the guide bar. To do maintenance on the fuel tank and the chain oil tank • Drain and clean the fuel tank and the chain oil tank regularly. • Replace the fuel filter yearly or more frequently if necessary. CAUTION: Contamination in the tanks causes malfunction. To adjust the chain oil flow WARNING: Stop the engine before you make adjustments to the oil pump. 30 140 - 007 - 04.06.2020