Husqvarna AUTOMOWER 450X EPOS Owner Manual - Page 28
right, left, Charging station blocked
View all Husqvarna AUTOMOWER 450X EPOS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Message Empty battery Slipped Wheel motor overloaded right, left Charging station blocked Stuck in charging station Upside down Mower tilted Lifted Collision Cause Action The product cannot find the charging sta- The product has no accurate position tion. and cannot find the charging station. There is an obstacle that prevents the product to find the charging station. The battery is at the end of its life cycle. Replace the battery. Refer to Battery on page 25. The antenna of the charging station is defective. If the LED indicator on the charging station flashes red, the antenna of the charging station is defective. Speak to your approved servicing dealer. The product has hit an obstacle and stopped or the wheels cannot move on the wet grass. Move the product and correct the cause of problem. If it is because of wet grass, wait until the lawn is dry before you use the product. The work area includes a steep slope. Maximum guaranteed slope is 45%. Steeper slopes should be isolated. Refer to To install the map objects in a slope on page 13. Grass or other objects is wound around Examine the drive wheel and remove the drive wheel. grass or other objects. The connection between the charging plates on the product and the contact plates on the charging station is not good. The product made a number of tries to charge. Put the product in the charging station and make sure that the charging plates and contact plates are connected. An object prevents the product to enter Remove the object. the charging station. The charging station tilts or is bent. Put the baseplate on level ground. An object prevents the product to move Remove the object. out from the charging station. The baseplate has a wet or dirty surface that prevents the product to move out from the charging station. Clean the baseplate of the charging station. The product tilts or is with the top down. Put the product in the correct position. The product tilts more than the maximum Move the product to an area that has lev- angle. el ground. The lift sensor was enabled because the Move the product. If the problem stays, product was lifted. speak to your approved servicing dealer. The body of the product cannot move freely around its chassis. Remove dirt or object between the chassis and the body of the product. Make sure that the body of the product can move freely around its chassis. The product cannot move forward or rearward. Remove the object that prevents the product from operation. 28 - Troubleshooting 1970 - 001 - 10.10.2022