Husqvarna K 535i Owner Manual - Page 11
Safety instructions for assembly, Safety instructions for maintenance
View all Husqvarna K 535i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
is shielded by the blade guard when you do this. Note: Make sure that you can not turn the locknut by hand. Replace the nut if the nylon lining does not have a resistance of a minimum of 1.5 Nm. The nut should be replaced after it has been put on approximately 10 times. Cutting attachment WARNING: Remove the battery and make sure that the cutting attachment stops completely before you work on any part of the cutting attachment. WARNING: Use correct cutting attachment. Only use the cutting attachment with the guards we recommend, refer to Accessories on page 29. Make sure that the cutting attachment is sharpened correctly. A cutting attachment that is not sharpened correctly increases the risk of blade thrust. WARNING: An incorrectly sharpened or damaged blade increases the risk of accidents. Keep the teeth of the blade correctly sharpened. Follow the instructions and use the recommended file gauge. WARNING: A coasting blade can cause injury while it continues to spin after the switch has been released. Need to maintain proper control until the blade has completely stopped rotating. CAUTION: An incorrectly set saw blade increases the risk of jamming and blade thrust. This can damage the saw blade. Keep the correct setting on the saw blade. Follow the instructions and use the recommended setting tool. Wear protective gloves when the cutting attachment is handled. • Use the saw blade to cut fibrous types of wood. • Use the blades and grass knives to cut coarse grass. • Use the trimmer head to trim grass. • Check the cutting attachment for damage or cracks. Replace a damaged cutting attachment. Trimmer head • Always use the correct trimmer head, cutting attachments and always use the recommended trimmer line. Refer to Accessories on page 29 and the assembly in the end of the Manual. • Make sure that the cutter on the trimmer guard is not damaged. • Make sure that the trimmer line is wound tightly and equally around the drum to prevent unusual vibrations from the product. Different cord lengths can result in vibrations that are not necessary. Tap the trimmer head to get correct length on the cord. To increase the life of the cord it can be soaked in water for 2 days or more before assembly. This will make the cord more resistant. Saw blade and grass blade • Use correctly sharpened blades. An incorrectly sharpened or damaged blade increases the risk of injury. • Use correctly set blades. Correct blade set is 1 mm. An incorrectly set blade increases the risk of injury and damage. • To sharpen and set the blade correctly, refer to the instructions that come with the blade. Safety instructions for assembly WARNING: Read, understand and obey these instructions carefully before you use the product. • Remove the battery from the product before you assemble the product. • Use approved protective gloves. • When you use a saw blade or a grass blade, make sure that the correct handlebar, the blade guard and the harness are attached to the product. • A defective or incorrect guard can cause injury. Do not use a cutting attachment that does not have an approved guard attached. • Make sure that you assemble the cover and shaft correct before you start the product. • The drive disc and support flange must engage correctly in the centre hole of the cutting attachment. A cutting attachment that is attached incorrectly can cause injury or death. • To operate the product safely and prevent injury to the operator or other persons, the product must always be attached correctly to the harness. Safety instructions for maintenance WARNING: Read the warning instructions that follow before you do maintenance on the product. 609 - 006 - 17.08.2020 11