Husqvarna LE221R Owner Manual - Page 15

1. Press the SavE button (A) to start the function. The green LED comes on. A 3. Open the battery lid and turn the safety key to 0. B 2. Press the SavE button again to stop the function. The green LED (B) goes out. The SavE function stops automatically if the ground conditions make it necessary to have a higher output. The SavE function starts automatically when the ground conditions lets it. High load function When the product cuts long or wet grass, the motor automatically increases rpm. The motor goes back to standard mode when high load is not necessary. To stop the product The product stops automatically if you do not operate it for 10 minutes. Always turn the safety key to 0 before you let the product out of view. 1. Release the motor brake handle to stop the motor. 2. Press the ON/OFF button (A) on the control panel and the green LED (B) goes out. A B 4. To remove the battery, press the two release buttons and pull out the battery. 5. Charge the battery if it is weak. For more information, see To charge the battery on page 13. To get a good result • Always use a sharp blade. A blunt blade gives an irregular result and the cut surface of the grass becomes yellow. A sharp blade also uses less energy than a blunt blade. • Do not cut more than ⅓ of the length of the grass. Cut first with the cutting height set high. Examine the result and lower the cutting height to an applicable level. If the grass is very long, drive slowly and cut 2 times if necessary. • Cut in different directions each time to prevent stripes in the lawn. To cut grass without a grass catcher or mulch plug attached • Lift up the rear cover and remove the grass catcher. • If a mulch plug and a mulch blade are attached, remove them. • Close the rear cover before you operate the product. When you operate the product, the cut grass discharges below the rear cover. 428 - 002 - 15