Husqvarna LE221R Owner Manual - Page 18

LED on the battery The error LED flashes The error LED is on Possible faults Possible procedure The battery is weak Charge the battery. See To charge the battery on page 13. The temperature in the work environ- Use the battery in temperatures between -10°C ment is too high or too low and 40°C. Overvoltage Check that the mains voltage is the same as on the rating plate on the product. Remove the battery from the battery charger. Wait 5 seconds and try again to charge the battery. If the problem continues, speak to an authorised service agent. Cell difference too much (1V) Speak to an approved service agent. Battery charger LED on the battery charger Possible faults The error LED flash- The temperature in the work en- es vironment is too high or too low The error LED is on Possible procedure Use the battery charger in temperatures between 5°C and 40°C. Speak to an approved service agent Control panel For problems, other than those in this section, speak to your service agent. Keypad Error code (Num- Possible faults ber of flashes) Possible action Error LED flashes 3 5 The motor is overloaded The motor speed drops too much, and the motor stops Increase the cutting height. See To set the cutting height on page 12. 10 The motor control is too hot Stop the motor and wait until it has be- come cool 2 The blade is blocked To prevent accidental start turn the safe- ty key to 0, remove the battery and wait a minimum 5 seconds. Make sure that the blade can rotate freely. If the prob- lem continues, speak to an authorised service agent 9 Battery error or no signal from Put the battery in the product correctly battery and examine the battery connector. If the error LED on the battery flashes, see Battery on page 13. The product stops 8 The battery is weak Charge the battery. See To charge the battery on page 13. 0 Battery connector failure Examine the battery connector 18 428 - 002 -