Husqvarna R 120S Owners Manual - Page 15

Driving Before starting IMPORTANT! The air intake grille in the engine cover behind the driver's seat must not be blocked by, for example, clothing, leaves, grass or dirt. Impaired cooling of the engine. Risk of major engine damage. With a cold engine: 4 Move the throttle to position 3 (choke position). In this position the engine is fed with a richer mixture, which means the engine is easier to start. 2 3 1 • Read the safety instructions and information concerning the placement of controls and functions before starting. • Perform daily maintenance before starting as set out in the Maintenance schedule. • Adjust the seat to the required position. Start the engine 1 Make sure the release lever is pushed in. (Run position) With a warm engine: 5 Move the throttle in between positions 1 and 2. 1 2 3 6 Turn the ignition key to the start position. 2 Lift up the cutting unit by pulling the lever backwards to its locked position. IMPORTANT INFORMATION If the engine does not start, wait about 15 seconds before trying again. If the engine does not start wait about 1 minute before trying again. 7 When the engine starts release the ignition key immediately back to neutral position. 3 Activate the parking brake. This is done as follows: 2 1 - Press down the parking brake pedal (1). - Press in the lock button (2) on the steering column. - Release the brake pedal while holding the button pressed. The parking brake lock disengages automatically when the brake pedal is pressed. 8 Push the throttle lever gradually rearward when the engine has started. Let the engine run at moderate speed or half throttle for 3-5 minutes before subjecting it to heavy load. 9 Set the required engine speed with the throttle control. WARNING! Never run the engine indoors, in ! enclosed or poorly ventilated areas. The exhaust fumes contain toxic carbon monoxide. English - 15