Husqvarna SG 13 Owners Manual - Page 17

handle to maximum position without any pull

Page 17 highlights

SET-UP 1 14. Insert "L" end of throttle cable into the outside hole of the engine throttle control lever. Figure 7. 2 FORWARD FIGURE 7 1. ENGINE THROTTLE CONTROL LEVER 2. THROTTLE CABLE 15. Attach the throttle cable to the engine using the double wire clamp removed in step nine. Figure 8. 16. Test throttle control by pulling back throttle handle on console. Throttle arm on engine should be pushed completely forward. Cable should not slip in clamp when doing this test. 17. Test proper wire length by pulling on the handle adjustment lever and raising and lowering the handle to maximum position without any pull on harness. 18. Reattach air cleaner to engine. 19. Unit is now ready to be removed from pallet. 1 FIGURE 8 1. THROTTLE CABLE 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50

17
FIGURE 7
SET-UP
FIGURE 8
14.
Insert ā€œLā€ end of throttle cable into the outside hole
of the engine throttle control lever.
Figure 7.
15. Attach the throttle cable to the engine using the
double wire clamp removed in step nine. Figure 8.
16. Test throttle control by pulling back throttle
handle on console. Throttle arm on engine
should be pushed completely forward. Cable
should not slip in clamp when doing this test.
17. Test proper wire length by pulling on the handle
adjustment lever and raising and lowering the
handle to maximum position without any pull
on harness.
18. Reattach air cleaner to engine.
19. Unit is now ready to be removed from pallet.
1. THROTTLE CABLE
2. THROTTLE CABLE
1. ENGINE THROTTLE
CONTROL LEVER
FORWARD
1
2
1