Husqvarna SG 13 Owners Manual - Page 29

IMPORTANT INFORMATION, If the cutting wheel is too low, the machine

Get Husqvarna SG 13 PDF manuals and user guides View all Husqvarna SG 13 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 29 highlights

OPERATION 5. Tilt the machine on its wheels, lifting the cutting wheel off the ground. 6. Hold in the dead man's grip bar and start the engine. 7. Allow the engine to warm up for two minutes at idle before grinding. 8. Set the throttle to FAST to ENGAGE clutch. IMPORTANT INFORMATION If the cutting wheel is too low, the machine may start to "climb" over the stump and become unstable. 9. Place the middle of the cutting wheel approximately one inch (2.5 cm) above and 3/4 to 1 1/2 inches (2-4 cm) into the stump. 10. Place the cutting wheel in the upper front edge of the stump. Swing the cutting wheel from side to side while lowering it about one inch (2.5 cm) after each pass until the front edge of the stump is gone. . 8011-202chg 8011-127 8011-185 8011-203 29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
29
OPERATION
6.
Hold in the dead man’s grip bar and start the
engine.
7.
Allow the engine to warm up for two minutes at
idle before grinding.
5.
Tilt the machine on its wheels, lifting the cutting
wheel off the ground.
8.
Set the throttle to FAST to ENGAGE clutch.
9.
Place the middle of the cutting wheel
approximately one inch (2.5 cm) above and
3/4 to 1 1/2 inches (2-4 cm) into the stump.
10. Place the cutting wheel in the upper front edge
of the stump. Swing the cutting wheel from side
to side while lowering it about one inch (2.5 cm)
after each pass until the front edge of the stump
is gone.
8011-185
8011-202chg
8011-203
8011-127
IMPORTANT INFORMATION
If the cutting wheel is too low, the machine
may start to “climb” over the stump and
become unstable.
.