Husqvarna SG 13 Owners Manual - Page 37

Disassembling and reassembling, the blade, pockets and teeth, R = Right mounting

Get Husqvarna SG 13 PDF manuals and user guides View all Husqvarna SG 13 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 37 highlights

MAINTENANCE IMPORTANT INFORMATION If pulley on cutter head shaft must be moved, the set screws MUST be fully removed, fresh "Loctite 242" put on threads and re-torqued to 100 - 110 in./lbs. (17513 / 19264 N•m). 7. Check that the pulleys are aligned using a staright edge along the inside face of the clutch and pulley. Pulleys must be inline. Maximum gap or misalignment is 1/16" (.062) or 15.7 mm. Adjust using the tension bolts as necessary. Check belt tension again. 8. Tighten all screws and nuts when the adjustment is complete. Be certain cover plate is not rubbing against cutter wheel shaft. 9. Refit the belt guard. 1 1. CHECK CLUTCH & PULLEY ALIGN USING INSIDE FACE 8011-229chg Disassembling and reassembling the blade, pockets and teeth IMPORTANT INFORMATION The cutters and pockets are mounted on the cutting wheel as illustrated. L = Left mounting R = Right mounting Ensure that the tooth cutters are turned in the cutting direction. 2 1 1. TOOTH CUTTER (CARBIDE FACE) 2. CUTTING DIRECTION 8011-215 37

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
37
IMPORTANT INFORMATION
The cutters and pockets are mounted on
the cutting wheel as illustrated.
L = Left mounting
R = Right mounting
Ensure that the tooth cutters are turned
in the cutting direction.
8011-215
MAINTENANCE
Disassembling and reassembling
the blade, pockets and teeth
7.
Check that the pulleys are aligned using a
staright edge along the inside face of the clutch
and pulley.
Pulleys must be inline. Maximum gap or mis-
alignment is 1/16” (.062) or 15.7 mm.
Adjust using the tension bolts as necessary.
Check belt tension again.
8.
Tighten all screws and nuts when the
adjustment is complete. Be certain cover plate
is not rubbing against cutter wheel shaft.
9.
Refit the belt guard.
8011-229chg
1. CHECK CLUTCH & PULLEY
ALIGN USING INSIDE FACE
IMPORTANT INFORMATION
If pulley on cutter head shaft must be
moved, the set screws MUST be fully
removed, fresh “Loctite 242” put on
threads and re-torqued to 100 - 110 in./lbs.
(17513 / 19264 N
•
m).
1. TOOTH CUTTER
(CARBIDE FACE)
2. CUTTING DIRECTION
1
1
2