Husqvarna Z254i Owners Manual - Page 9

SAFETY • Remove gas-powered equipment from the truck or trailer and refuel it on the ground. If this is not possible, refuel such equipment with a portable container, rather than from a gasoline dispenser nozzle. • Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. Do not use a nozzle lock-open device. • If fuel is spilled on clothing, change clothing immediately. • Do not start the engine near spilled fuel. • Never use gasoline as a cleaning agent. • If leaks arise in fuel system, the engine must not be started until problem has been resolved. • Check the fuel level before each use and leave space for the fuel to expand, as the heat from the engine and the sun may otherwise cause the fuel to expand and overflow. CAUTION! Use protective glasses for maintenance work. General Maintenance • Never use the machine indoors or in spaces lacking proper ventilation. The exhaust fumes contain carbon monoxide, an odorless and poisonous lethal gas. • Make sure that the equipment is in good condition and that all nuts and bolts, especially those fastening the blade attachments, are properly tightened and torqued. • Maintain or replace safety and instruction labels as necessary. • Never interfere with the intended function of a safety device or reduce the protection provided by a safety device. Check their proper operation regularly. NEVER operate a machine with a safety device that does not function properly. WARNING! The engine must not be started when the driver's floor plate or any protective plate for the mower deck's drive belt is removed. • Check grass catcher components and the discharge guard frequently and replace with manufacturer's recommended parts when necessary. • Do not change the settings of governors and avoid running the engine with overly high engine speeds. If you run the engine too fast, machine components could be damaged. • To reduce the risk of fire, keep machine free of grass, leaves or other debris buildup. Clean oil or fuel spills and remove any fuel-soaked debris. Allow machine to cool before storing. • Stop to inspect the equipment if you run over or into anything. If necessary, make repairs before starting. • Never make adjustments or repairs with the engine running. • The blades are sharp and can cause cuts and gashes. Wrap the blades or use protective gloves when handling them. • Check park brake operation frequently. Adjust and service as required. • Never work with the starter circuit if there is spilled fuel. • Ensure that the fuel filler cap is mounted tightly and no flammable substances are stored in an open vessel. • Sparking can occur when working with the battery and the heavy cables of the starter circuit. This can cause battery explosion, fire or eye injury. Sparking will not occur after the grounding cable (normally negative, black) is removed from the battery. • Disconnect the grounding cable from the battery first and reconnect it last. • Do not make a bridge short circuit across the starter relay to run the starter. • Be very careful when handling battery acid. Acid on skin can cause serious corrosive burns. If you spill battery acid on your skin, rinse immediately with water. • Acid in the eyes can cause blindness, contact a doctor immediately. • Be careful when servicing the battery. Explosive gases form in the battery. Never perform maintenance on the battery when smoking or near open flames or sparks. The battery can explode and cause serious injury or damage. WARNING! The battery contains lead and lead compounds, chemicals that are considered to cause cancer, birth defects, and other reproductive system damage. Wash your hands after handling the battery. • The machine is tested and approved only with the equipment originally provided or recommended by the manufacturer. Only use approved repair parts for the machine. • The mulch blades should only be used in familiar areas when higher quality mowing is desired. • Regularly clean deck and underside of deck, avoid spraying engine and electrical components with water. 9