IBM 2019A1X Installation Guide - Page 33

Removing the battery, IBM Systems Environmental Notices and User Guide, Documentation

Get IBM 2019A1X - Bladecenter Advanced Management Module PDF manuals and user guides
UPC - 883436070805
View all IBM 2019A1X manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

Removing the battery The management module battery is not a field or customer replaceable item. When a management module is no longer needed, remove the battery from the module and recycle or properly dispose of both the management module and battery according to applicable local and national ordinances or regulations. (See the IBM Systems Environmental Notices and User Guide document on the IBM Documentation CD for additional information). To remove the battery, complete the following steps: 1. Read the safety information that begins on page v and the "Installation guidelines" on page 11. 2. If the management module is installed in a BladeCenter unit, remove it (see "Removing a management module" on page 15). 3. Open the management module cover by lifting the rear edge. 4. Locate the battery. The battery is typically located on the side of the management module system board closest to the bezel. 5. Insert fingertip under the battery and gently lift. The battery should pop free. 6. If necessary, use a small flat-tip screwdriver to pry the battery loose. 7. Dispose of the battery as required by local ordinances or regulations. Chapter 3. Installing a management module 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
Removing the battery
The management module battery is not a field or customer replaceable item.
When a management module is no longer needed, remove the battery from the
module and recycle or properly dispose of both the management module and
battery according to applicable local and national ordinances or regulations.
(See the
IBM Systems Environmental Notices and User Guide
document on the
IBM
Documentation
CD for additional information).
To remove the battery, complete the following steps:
1.
Read the safety information that begins on page v and the “Installation
guidelines” on page 11.
2.
If the management module is installed in a BladeCenter unit, remove it (see
“Removing a management module” on page 15).
3.
Open the management module cover by lifting the rear edge.
4.
Locate the battery. The battery is typically located on the side of the
management module system board closest to the bezel.
5.
Insert fingertip under the battery and gently lift. The battery should pop
free.
6.
If necessary, use a small flat-tip screwdriver to pry the battery loose.
7.
Dispose of the battery as required by local ordinances or regulations.
Chapter 3. Installing a management module
23