Home » IBM Manuals » Desktops » IBM 6269 » Manual Viewer

IBM 6269 User Guide - Page 139

Class A notices, Federal Communications Commission (FCC) statement - netvista manual

UPC - 087944629900

Add to My Manuals
Save this manual to your list of manuals

Page 139 highlights

This product has been tested and found to comply with the limits for Class B Information Technology Equipment according to CISPR 22/European Standard EN 55022. The limits for Class B equipment were derived for typical residential environments to provide reasonable protection against interference with licensed communication devices. Class A notices NetVista A20 Types 6269, NetVista Types 6568, 6578, and 6648, NetVista A40p Types 6569, 6579, and 6649 Federal Communications Commission (FCC) statement Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense. Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. IBM is not responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Industry Canada Class A emission compliance statement This Class A digital apparatus complies with Canadian ICES-003. Avis de conformité à la réglementation d'Industrie Canada Cet appareil numérique de classe A est conforme à la norme NMB-003 du Canada. Australia and New Zealand Class A statement Attention: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. Appendix E. Notices and trademarks 121

Section	Page
Safety information	5
Lithium battery notice	7
Modem safety information	7
Laser compliance statement	8
About this book	11
Related information	11
Contents	13
Chapter 1. IBM NetVista computer overview	19
Identifying your computer	19
Small form factor desktop models	20
Desktop models	21
Features	22
Chapter 2. Setting up your computer	25
Selecting a location for your computer	25
Connecting computer cables	25
Turn on power	29
Finish the installation	30
Arranging your workspace	31
Comfort	31
Glare and lighting	32
Air circulation	32
Electrical outlets and cable lengths	32
Chapter 3. Operating and caring for your computer	33
Starting your computer	33
Using video features	33
Video device drivers	34
Changing monitor settings	34
Using audio features	35
Using diskettes	36
Handling and storing diskettes	36
Inserting and removing diskettes	36
Using a CD-ROM drive	36
Handling a CD	37
Loading a CD	37
Using the IBM ScrollPoint II mouse	38
Updating system programs	39
Using network management tools	39
Wake on LAN	40
Remote Program Load or Dynamic Host ConfigurationProtocol	40
Remote Administration	40
LANClient Control Manager (LCCM)	40
System Migration Assistant (SMA)	41
Desktop Management Interface	41
Using security features	41
Anti-intrusion features	41
Component protection	41
Asset ID capability	42
IBM security solutions	42
Data protection	43
SMART hard disk drive	43
SMART Reaction	43
Virus protection	43
Enhanced Security	43
Locking the keyboard	43
Shutting down	44
Taking care of your computer	44
Basics	44
Cleaning your computer	44
Computer and keyboard	45
Monitor screen	45
Mouse	45
Moving your computer	46
Chapter 4. Using the Configuration/Setup Utilityprogram	47
Starting and using the Configuration/Setup Utility program	47
Viewing and changing settings	48
Exiting from the Configuration/Setup Utility program	49
Using System Security	49
Using Enhanced Security	49
Using Security Profiles by Device	50
Setting Remote Administration	51
Using passwords	52
Using a power-on password	52
Setting, changing, and deleting a power-on password	53
Using an administrator password	54
Setting, deleting, or changing an administrator password	54
Erasing a lost or forgotten password (clearing CMOS)	55
Using Adapter ROM security	55
Using the IBM Embedded Security Chip	55
Enabling the Pentium III processor serial number feature	56
Other settings in the Configuration/Setup Utility program	56
Changing keyboard speed	56
Changing the primary startup sequence	56
Enabling the Error Startup Sequence	57
Power-management features	57
ACPI BIOS IRQ	57
ACPI Standby Mode	58
Setting power-management features	58
Setting automatic power-on features	59
Chapter 5. Installing options	61
Handling static-sensitive devices	61
Available options	61
Tools required	62
Removing the cover	63
Locating components—small form factor desktop model	64
Locating components—desktop model	65
Installing options on the system board and riser card (somemodels)	66
Accessing the system board	66
Identifying parts on the system board	66
Components of the A40 and A40p system board	67
Components of the riser card for small form factor desktop models	68
Components of the A20 system board	69
Installing memory	69
Installing adapters	71
Adapter slots	71
Installing adapters — small form factor desktop model	72
Installing adapters — desktop model	74
Installing internal drives	76
Drive specifications — small form factor desktop model	77
Drive specifications — desktop model	78
Power and signal cables for internal drives	79
Installing internal drives in the desktop model computer	81
Installing a security U-bolt	84
Completing the installation	84
Replacing the cover and connecting the cables	84
Updating the computer configuration	85
Starting the Configuration/Setup Utility program	86
Configuring startup devices	87
Chapter 6. Troubleshooting	89
Troubleshooting procedure	89
Power-on self-test (POST)	91
Diagnostic error codes and messages	91
POST error codes	91
POST beep codes	95
Ethernet error messages	96
RPL-related error messages	96
DHCP-related error messages	97
Device troubleshooting charts	98
General problems	99
Intermittent problems	100
Audio problems	101
CD-ROM drive problems	102
Diskette drive problems	104
Monitor problems	104
Keyboard, mouse, or pointing device problems	107
Memory problems	108
Option problems	109
Parallel-port problems	110
Serial-port problems	110
Printer problems	111
Application problems	111
Universal Serial Bus (USB) problems	112
Software-generated error messages	112
IBM Enhanced Diagnostics program	112
Other diagnostic programs on the Software Selections CD	114
Recovering from a POST/BIOS update failure	114
Installing files from option diskettes	115
Replacing the battery	115
Chapter 7. Getting help, service, and information	117
Getting information	117
Using the World Wide Web	117
Getting information by fax	117
Getting help and service	118
Using the documentation and diagnostic programs	118
Calling for service	118
Other services	120
Purchasing additional services	121
Appendix A. Using the Software Selections CD	123
Features of the Software Selections CD	123
Starting the Software Selections CD	124
Using the Software Selections program	124
Appendix B. Specifications	125
Specifications — small form factor desktop model	125
Specifications — desktop model (A40 and A40p)	126
Specifications — desktop model (A20)	127
Appendix C. Placing the computer on its side	131
Placing the small form factor desktop computer on its side	131
Placing the desktop computer on its side	131
Appendix D. Computer records	133
Appendix E. Notices and trademarks	135
Processing date data	136
Television output notice	136
Trademarks	136
Electronic emissions notices	137
Class B notices	137
Federal Communications Commission (FCC) statement	137
Class A notices	139
Federal Communications Commission (FCC) statement	139
Industry Canada Class A emission compliance statement	139
Avis de conformité à la réglementation d’Industrie Canada	139
Australia and New Zealand Class A statement	139
European Union EMC Directive conformance statement	140
Taiwan Class A warning statement	140
Federal Communications Commission (FCC) and telephonecompany requirements	140
Canadian Department of Communications certification label	141
Étiquette d’homologation du ministère des Communications duCanada	142
Power cord notice	143

Match case Limit results 1 per page

This product has been tested and found to comply with the limits for Class B

Information Technology Equipment according to CISPR 22/European Standard

EN 55022. The limits for Class B equipment were derived for typical residential

environments to provide reasonable protection against interference with

licensed communication devices.

Class A notices

NetVista A20 Types 6269, NetVista Types 6568, 6578, and 6648, NetVista A40p

Types 6569, 6579, and 6649

Federal Communications Commission (FCC) statement

Note:

This equipment has been tested and found to comply with the limits for

a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a

residential area is likely to cause harmful interference, in which case the user

will be required to correct the interference at his own expense.

Properly shielded and grounded cables and connectors must be used in order

to meet FCC emission limits. IBM is not responsible for any radio or television

interference caused by using other than recommended cables and connectors or

by unauthorized changes or modifications to this equipment. Unauthorized

changes or modifications could void the user

’

s authority to operate the

equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference,

and (2) this device must accept any interference received, including

interference that may cause undesired operation.

Industry Canada Class A emission compliance statement

This Class A digital apparatus complies with Canadian ICES-003.

Avis de conformit

éà

la r

glementation d

’

Industrie Canada

Cet appareil num

rique de classe A est conforme

la norme NMB-003 du

Canada.

Australia and New Zealand Class A statement

Attention:

This is a Class A product. In a domestic environment this product

may cause radio interference in which case the user may be required to take

adequate measures.

Appendix E. Notices and trademarks

121