IBM 6500-V10 Maintenance Manual - Page 325
Cover Assembly, Hammer Bank / Ribbon Mask, Removal, Installation
View all IBM 6500-V10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 325 highlights
Cover Assembly, Hammer Bank / Ribbon Mask Cover Assembly, Hammer Bank / Ribbon Mask Removal 1. Prepare the printer for maintenance (page 313). 2. Remove the shuttle frame assembly (page 362). 3. Lift the thick plate of the hammer bank cover assembly at one end, and peel the cover away from hammer bank magnets. (See Figure 15, page 325.) ATTENTION Installation The hammer bank contains a strong magnet. To prevent damage to the hammer tips, do not let the hammer bank cover assembly snap into place as the hammer bank magnet attracts it. Any impact of the cover against the hammer bank can break hammer tips. 1. With the thick plate facing the hammer bank, hold the hammer bank cover assembly at a slight angle and engage the bottom edge on the alignment pins. First engage the center (round) hole, then the left (oblong) hole, to ensure that the cover lies flat on the hammer bank. (See Figure 15, page 325.) 2. Gently lower the hammer bank cover assembly until it lies flush on the hammer bank. 3. Check that the hammer bank cover assembly is positioned over the alignment pins and the hammer tips. 4. Install the shuttle frame assembly (page 362). 5. Return the printer to normal operation (page 314). Oblong Hole Hammer Bank Cover Assembly Round Hole Alignment Pin Figure 15. This figure shows how to install the hammer bank cover assembly. 325