IBM 6500-V10 Maintenance Manual - Page 82
contact your DDS and Second Level Support., CONTROL VOLT CHECK, SEE USERS MANUAL
View all IBM 6500-V10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Operator Panel Message 085 CONTROL VOLT CHECK SEE USERS MANUAL Display Messages Table 3. Message List Explanation Corrective Action Controller voltage failure. 1. Cycle Power. Run the print job again. If the message appears, download the emulation software again. 2. Cycle power. Run the print job again. If the message appears, replace the flash memory with blank flash with boot code and download code. 3. Check the shuttle for electrical shorts (page 252). 4. Power on the printer. If the problem reappears, the controller board or microcode is suspect. Do the following: 5. Save the printer configuration values. (Refer to the User's Manual.) 6. Clear NVRAM (page 237). 7. Download and install the latest code from IBM First (page 231). 8. Power on the printer in download mode and load flash memory (page 238). a. If you encounter loading problems, go to the appropriate error code for resolution. b. If you encounter the failure or message that brought you to this procedure, replace the controller board (page 319). After replacing the controller board, DO NOT make the printer READY, but proceed immediately to the next step. 9. Download and install the latest code from IBM First (page 231). 10. Power on the printer in download mode and load flash memory (page 238). 11. If you encounter the failure after replacing the controller board, reinstall the original controller board and contact your DDS and Second Level Support. 12. Power on the printer. Run the print job again. If the message appears, do the power supply operational check (page 258). If the power supply fails the check, replace it. If it passes the check, contact your DDS and Second Level Support. 82