IBM 7026-H80 Service Guide - Page 380
Firmware to I/O interface, update was aborted before any
View all IBM 7026-H80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 380 highlights
Table 8. Common Firmware Error Codes (continued) Error Code Description Action/ Possible Failing FRU B1xx 4695 System power control network to service processor interface failure 1. Check for system firmware update 2. Primary I/O backplane Location: U0.1-P1 B1xx 4696 System firmware interface failure 1. Check for system firmware update. 2. Call service support. B1xx 4698 Firmware problem 1. Check for system firmware update. 2. Call service support. B1xx 4699 Service processor firmware 1. Check for system firmware update 2. Call service support. B1xx 469A System firmware interface 1. Check for system firmware update 2. Call service support. B1xx 469B Firmware to I/O interface 1. Check for system firmware update 2. Primary I/O backplane Location: U0.1-P1 B1xx 469C Firmware to I/O interface 1. Check for system firmware update 2. Primary I/O backplane Location: U0.1-P1 B1xx 469E Service processor firmware failure 1. Check for system firmware update 2. Go to "MAP 1540: Minimum Configuration" on page 113, CEC minimum config 3. Primary I/O backplane Location: U0.1-P1 B1xx 469F Service processor failure 1. Check for system firmware update 2. Go to "MAP 1540: Minimum Configuration" on page 113, CEC minimum config 3. Primary I/O backplane Location: U0.1-P1 B1xx 8FF0 Informational message No action required B1FD 0013 A firmware update has failed because Reset the service processor (by the update image is invalid. The activating the pinhole reset switch or update was aborted before any by disconnecting, then reconnecting changes were made to the currently power). Install a valid firmware installed firmware. update image for the specific system type and model. 362 Service Guide