IBM 847681U Hardware Maintenance Manual - Page 73

Installing or removing AGP adapters: This section gives the procedure for installing an AGP adapter in the dedicated AGP slot connector. If you want to remove an AGP adapter from this slot connector, reverse the order of the following steps. If you need to install an adapter in an ISA or PCI slot connector, go to "Installing or removing ISA and PCI adapters" on page 62. Notes 1. You may install a video adapter in the dedicated AGP slot connector, in an ISA slot connector, or in a PCI slot connector. However, the server system board supports either the integrated video subsystem or the AGP video connector, but not both simultaneously. 2. You can install only a special AGP graphics adapter in the dedicated AGP slot connector. For information on the available AGP adapters, go to http://www.ibm.com/pc/us/compat/ on the World Wide Web. Note Read "Safety information" on page 212. Read the documentation that comes with the option. Read "Accessing the system board" on page 59. Attention The presence of 5 V ac standby power might result in damage to the hardware unless you disconnect the power cord from the electrical outlet before you open the server. To install an AGP adapter: 1. Remove the server side cover (see "Disconnecting cables and removing the side cover" on page 84). 2. Remove the screw; then, remove the cover to access the two slots on the server wall. The slots on the server wall provide access to the connector on the AGP adapter for attaching external devices. IBM Netfinity 3000 - Type 8476 65