IBM 849130u Installation Guide - Page 23
Installing, simple-swap, Serial, drive
![]() |
UPC - 000435947147
View all IBM 849130u manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Installing a simple-swap Serial ATA hard disk drive Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all power from the server before removing or installing a simple-swap hard disk drive. To install a simple-swap Serial ATA hard disk drive, complete the following steps. Note: If you have only one hard disk drive, install it in the left drive bay. Attention: To avoid damage to the hard disk drive connectors, make sure that the cover is in place and fully closed whenever you install or remove a hard disk drive. 1. Read the safety information that begins on page v and "Installation guidelines" on page 7. 2. Make sure that the server cover is in place and fully closed. 3. Turn off the server and peripheral devices, and disconnect the power cord and all external cables. 4. Remove the filler panel from the bay. 5. Pull the loops of the tray toward each other and slide the drive into the server until the drive connects to the back panel. 6. Insert the filler panel into the bay to cover the drive. Notes: 1. If the server has a RAID controller or adapter installed, you might need to reconfigure the disk arrays after installing hard disk drives. See the documentation that comes with the adapter for more information. 2. To remove a simple-swap SATA drive from the bay, make sure that the server is turned off and the power cord is removed: then, remove the filler panel, pull the loops of the drive tray toward each other and pull the tray out of the bay. If you have other options to install, do so now. Otherwise, go to "Completing the installation" on page 15. Chapter 2. Installing options 11
![](/manual_guide/products/ibm-849130u-installation-guide-83e8538/23.png)