IBM 86802SY Installation Guide - Page 6

with different electrical potentials., cables to prevent a possible shock from touching two surfaces

Get IBM 86802SY - Netfinity 7000 M10 PDF manuals and user guides
UPC - 087944496816
View all IBM 86802SY manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

1 DANGER To avoid a shock hazard, do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this product during an electrical storm. To avoid shock hazard: - The power cord must be connected to a properly wired and earthed receptacle. - Any equipment to which this product will be attached must also be connected to properly wired receptacles. When possible, use one hand to connect or disconnect signal cables to prevent a possible shock from touching two surfaces with different electrical potentials. Electrical current from power, telephone, and communications cables is hazardous. To avoid shock hazard, connect and disconnect cables as described following when installing, moving, or opening covers of this product or attached devices. To Connect 1. Turn Everything OFF. 2. First, attach all cables to devices. 3. Attach signal cables to receptacles. 4. Attach power cord(s) to outlet. 5. Turn device ON. To Disconnect 1. Turn Everything OFF. 2. First, remove power cord(s) from outlet. 3. Remove signal cables from receptacles. 4. Remove all cables from devices. NOTE: In the UK, by law, the telephone cable must be connected after the power cord. NOTE: In the UK, the power cord must be disconnected after the telephone cable. 4 Netfinity 7000 M10 Express Setup and Installation

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
1
DANGER
To avoid a shock hazard, do not connect or disconnect any
cables or perform installation, maintenance, or reconfiguration
of this product during an electrical storm.
To avoid shock hazard:
–
The power cord must be connected to a properly wired and
earthed receptacle.
–
Any equipment to which this product will be attached must
also be connected to properly wired receptacles.
When possible, use one hand to connect or disconnect signal
cables to prevent a possible shock from touching two surfaces
with different electrical potentials.
Electrical current from power, telephone, and communications
cables is hazardous.
To avoid shock hazard, connect and
disconnect cables as described following when installing,
moving, or opening covers of this product or attached devices.
To Connect
1. Turn Everything OFF.
2. First, attach all cables to devices.
3. Attach signal cables to receptacles.
4. Attach power cord(s) to outlet.
5. Turn device ON.
To Disconnect
1. Turn Everything OFF.
2. First, remove power cord(s) from
outlet.
3. Remove signal cables from
receptacles.
4. Remove all cables from devices.
NOTE: In the UK, by law, the telephone
cable must be connected after the power
cord.
NOTE: In the UK, the power cord must be
disconnected after the telephone cable.
4
Netfinity 7000 M10 Express Setup and Installation